Foam-Tubing Seal

Author Archives: American Woodworker Editors

Foam-Tubing Seal

American Woodworker Editors AW147, DIY, Dust, Dust Collection, Dust Collectors, Techniques, Tricks of the Trade, Workshop Tips

After hooking up my new dust collector to my contractor’s saw, I found that it just didn’t pull as much air as I’d like, even after sealing up the most obvious leaks. After further inspection, I found the problem: major …
Source

Comments Off

Crosscut Sled Cam Clamp

American Woodworker Editors AW133, CAM, Clamping, Clamps, crosscut, sled, Techniques, Tricks of the Trade

CROSSCUT SLED CAM CLAMP I use a sled for cross cutting 3/4-in. melamine and plywood panels up to 24 inches wide. These panels can be hard to hold in position while making a cut, so I installed a cam lever …
Source

Comments Off

Collapsible Drying Rack

American Woodworker Editors AW137, Finishing, Finishing Techniques, Shop Tips, Tricks of the Trade, Workshop Tips

Sturdy yet collapsible is easier said than done, but this drying rack is both. It folds flat against the wall to save space until I need it. I made my rack 36 in. tall, with 8 in. between levels. Each …
Source

Comments Off

Hook for Inset Doors

American Woodworker Editors AW161, Cabinets, Doors, Techniques, Tricks of the Trade, Workshop Tips

Have you ever closed an inset door in a cabinet you were building and found that you couldn’t open it, because you hadn’t added the knob yet? Well, I have. Here’s an easy, effective solution: Make a little hook from …
Source

Comments Off

Shelf Liner Sanding Pad

American Woodworker Editors AW143, Finishing, Sanding, Sandpaper, Shelves, Techniques, Tricks of the Trade, Workshop Tips

One roll of shelf liner will provide a lifetime supply of pads to improve the performance of your sanding block. I bought a 18″ x 48″ roll at a local home center for about $5. At about 3/32″ thick, I …
Source

Comments Off

« 1 … 8 9 10 11 12 … 39 »