Clamp Spacers
While I was gluing up the pedestals for an oak desk, I realized I needed a way to hold the sides parallel at the front. Three Quick-Grip clamps and a scrap wood spacer did the trick. They installed in seconds …
Source
Author Archives: American Woodworker Editors
No-Fuss Flush Trimming
My flush-trimming setup allows trimming veneer and solid wood edging up to 7/8-in. thick. It consists of a router with a 1/2-in. straight bit, a table and a perpendicular fence. A 1″-thick spacer separates the fence and table. The router …
…
Mobile Suction
My dust collector, though pieced-together, is the perfect solution for my one-car garage shop. I use a cyclone separator and 5-gallon bucket in conjunction with my shop vacuum. For easy mobility, I combined the two units on one 1/2″ thick ……
Read more13 Dust Collection Tips for A Cleaner Shop
Practical solutions for a cleaner shop Vacuum-Assisted Bench I got tired of hooking my bench tools to my shop vac. Now I simply plug their dust collection hoses into the bench. I drilled and routed a hole in the bench …
Source
Shoot from the Blue Line
I use a piece of painter’s tape to mark dadoes when I assemble cabinets. Then I know exactly where to shoot nails or install screws and there aren’t any pencil lines to sand off when I’m finished. I just remove …
Source