Zap the Gap
I hated the black hole that appeared when I installed corner bifold doors in my kitchen cabinets. To get rid of this annoying gap, I decided to make the main door (the one with the hinges) 3/4-in. wider, so it …
Source
Author Archives: American Woodworker Editors
Saddle Stop Block
Here’s a no-frills, adjustable block for making stopped cuts. Cut three pieces of 3/4″ plywood sized to fit your tablesaw’s rip fence. Install a T-nut in one of the side pieces before assembly. Thread a short piece of threaded rod …
Source…
Adjustable Support
I frequently need an outfeed table or work support for long pieces, so I built this T-shaped assembly to use in conjunction with my Black & Decker Workmate. The table is just a horizontal board that’s dadoed, glued and …
Source
No-Rack Vise
A workpiece ALWAYS SLIPS when placed vertically in my vise, because the vise racks. To solve the problem, I made a vise spacer from a 1”x 2”x 6” hardwood block, a 1/4” T-nut, a 1/4” x …
Source
Cheap Panel Clamps
I ran short of clamps in the heat of making a set of panel doors, so I quickly made more from stuff I had in my shop. These clamps are based on an old design, but the idea still works …
Source