Breezy Bandsawing Reasoning that I’d only be cutting small stuff in my basement shop, I parked my bandsaw diagonally in a corner. Then I decided to make one of those arched-top garden arbors. My old jig saw had burned out, …
Source
Finishing the plugs for covering screw holes is a pain. When you run a brush or rag over them after they’re installed, they’ll probably cause the finish to run or drip. Finishing them before they’re installed is the answer, but ……
Read moreI’ve had trouble making square and smooth edges on face frame parts, but this planer jig solved all my problems. It produces accurate and consistent results. For the jig’s base, cut T-slots in a 3/4” x 11” board that’s a …
Source
My finishing turntable is perfect for spraying large parts or projects. To make the device, I mounted five fixed 3-1/2” casters on a plywood panel. They’re equally spaced in a 16” diameter circle. Fixed casters won’t pivot, so the project …
Sourc…
Trimming small parts on a table saw using a miter gauge can be a little nerve wracking. In order to trim small parts safely, I mounted a handscrew to a piece of plywood. First I trimmed the plywood on the …
Source