Two-Screw Technique
As hard as I try to avoid it, every now and then I need to mill a small part on the router table. I’ve learned the hard way that you should never hold that part by hand, for three good …
Source
As hard as I try to avoid it, every now and then I need to mill a small part on the router table. I’ve learned the hard way that you should never hold that part by hand, for three good …
Source
A tenon should be one-third the thickness of a rail—at least, that’s what an old rule of thumb recommends. A 3/4″ board should have 1/4″ tenons, for example. But what about a 7/8″ board? What’s one-third of that? I use …
Source…
Separate, sort, and see your collection With just five different parts to make, this easy-to-build caddy accommodates bits with both 1/2″ and 1/4″ shafts. It can be customized to handle just about any collection. Long bits have plenty of ro…
Read moreTo mark the exact center of a board, I measure an equal distance from both ends and make two marks. This distance is just an approximation—it doesn’t matter if it’s longer or shorter than exactly half the length of the …
Source
The price of good turning tools can be pretty steep. Since most of the better lathe tools can be purchased without a handle, put your money where it counts—in the steel, not the handle. After all, it’s the steel that …
Source