Lathe Tool Wedgie
My lathe tool rack is based on a fishing rod rack that I made some time ago. Made from 3/4-in.-thick walnut, it measures 3-1/8-in. by 10-in. by 30- in. I made the matching front and back tool supports by ripping …
Source
My lathe tool rack is based on a fishing rod rack that I made some time ago. Made from 3/4-in.-thick walnut, it measures 3-1/8-in. by 10-in. by 30- in. I made the matching front and back tool supports by ripping …
Source
While I was gluing up the pedestals for an oak desk, I realized I needed a way to hold the sides parallel at the front. Three Quick-Grip clamps and a scrap wood spacer did the trick. They installed in seconds …
Source
My flush-trimming setup allows trimming veneer and solid wood edging up to 7/8-in. thick. It consists of a router with a 1/2-in. straight bit, a table and a perpendicular fence. A 1″-thick spacer separates the fence and table. The router …
…
After brushing the first coat of finish on my shelf project, quite a bit remained in the disposable cup. I didn’t want to pour it back, because that would contaminate the fresh finish that remained in the can. But I …
Source
After brushing the first coat of finish on my shelf project, quite a bit remained in the disposable cup. I didn’t want to pour it back, because that would contaminate the fresh finish that remained in the can. But I …
Source