My bandsaw’s blade-tensioning system used to be wobbly and difficult to turn. Instead of shelling out for a quick-release lever, I came up with this simple, inexpensive fix. To stabilize the long adjustment rod, I made a guide for it …
Source
Using a tablesaw to cut rabbets on the end of a board is nothing new. If you’ve only got a couple to make, it’s hardly worth the time it takes to install you dado set. So, using your fence in …
Source
If you use a cyclone dust collector, you’ve no doubt struggled with emptying the barrel. When it’s filled with dust, it’s really heavy, not to mention the face full of dust you get when you dump it out. The answer …
Source
How do you know when your miter gauge is set exactly at 90°? Here’s a method I learned years ago, before I could afford a precision square to check the cut. You’ll need a 24″ long board that is flat …
Source
Here’s a trick for I use for removing a stubborn router bit from the collet. I cut 1/2″ wide slots in a few credit card-size pieces of laminate. I then slide as many cards as I can fit between the …
Source