I make my own zero-clearance throat plates for my table saw to minimize exit tear-out on workpieces and to prevent narrow pieces from dropping into the saw. When raising the blade through the insert blank for the first time (using …
Source
I ran short of clamps in the heat of making a set of panel doors, so I quickly made more from stuff I had in my shop. These clamps are based on an old design, but the idea still works …
Source
I have a couple tools from which I frequently remove the dust collector hoses. I got tired of getting out my screwdriver and cranking out the adjustment bolt every time. After a bit of experimenting I came up with this …
Source
This pipe-clamp adaptation allows just a few clamps to replace a whole stack of pipes of different lengths. And the whole system fits into a shoebox.
Read moreErik Curtis shows his methods for gluing up angled cuts.
Read more