Edge-joining Thin Boards
Thin boards glued edge to edge have a tendency to spring out of place when pressure is applied to the bar clamps. A simple solution is to use short, notched clamping cauls at the ends of the joints. The cauls …
Source
Thin boards glued edge to edge have a tendency to spring out of place when pressure is applied to the bar clamps. A simple solution is to use short, notched clamping cauls at the ends of the joints. The cauls …
Source
I really like my round Veritas bench dogs because they’re so versatile and easy to install. The only problem I have with them is raising the less accessible ones when they’re tucked down flush in their holes. My bench is …
Source
I don’t use my machinist’s vise often enough to dedicate any of my limited bench space to it. Instead, I keep it tucked under a nearby cabinet for occasional use. I bolted the vise to a board that has a …
Source
Designer and builder of elegant but simple iconic furniture. Editor’s note: This piece was originally published in the December 2009 issue of Popular Woodworking in memoriam of Sam’s passing that year. Sam Maloof is the reason I became a &#…
Read moreI use a portable circular saw to break down plywood and other sheet goods into manageable pieces before bringing them to the table saw for final sizing. I prefer to do the job on sawhorses rather than crouching on the …
Source