Stock Sizing Board
Planing stock to fit standard dados is much easier than trying to find the right chipper and shim combination to fit the dado to your stock. I cut five grooves in a scrap of plywood, using only the blades and …
Source
Category Archives: DIY
Budget Spring Clamp
This light-duty clamp is ideal for small parts-and easy to make by the dozen. All you need are a couple wood scraps, a rubber band, and a short piece of dowel rod. You can vary the pressure by changing the …
Source
Wide-Mouth Dust Collection
The dust collection port on my sliding miter saw missed a lot of sawdust, so I added an additional port mounted directly behind the blade. The port is a piece of 3-in. ABS pipe that’s cut at 45 degrees to …
Source
Make Your Own Blast Gates
They’re cheap! All you need is some PVC and plastic laminate. A central dust collection system is a big improvement to any shop, but the cost can really add up. With commercial gates going from $4 to over $50 each, …
Source
Double Duty Peg-Blocks
I needed a way to lift pieces off the surface of my bench for finishing, so I made some 3/4″ x 2″ x 3″ blocks and inserted 1/4″ x 1-1/4″ dowels into them. Here’s the bonus: I discovered that if …
Source