It is estimated that nearly 80 percent of all woodworking requires some type of sawing. The power, accuracy and control of the table saw has made the process of sawing wood a lot more productive and a lot less physical. …
Source
A nice scraper burnisher can be made quickly for little or no cost. All you need is a cheap wooden file handle (available at hardware stores) and an old drill bit. You simply drill into the handle, then leave the …
Source
Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the spinning …
Source
Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the spinning …
Source
In my work I often need to draw large-radii curves, for which I use this long beam compass. Built from scrap wood and a dowel center, it’s cheap and easy to make in any length. It can be quickly adjusted …
Source