I made some half-overlay frame-and-panel doors recently, installing the panel a bit proud of the rails and stiles on the front, which recessed the panel on the back side. This isn’t an aesthetic problem, but it does create difficulty when …
Source
Replace your router’s base with one that is oversized and stable. The router can be a great friend in the woodshop, but it’s one of those friends with character traits that aren’t welcome in all situations. Like the fraternity …
Source
As hard as I try to avoid it, every now and then I need to mill a small part on the router table. I’ve learned the hard way that you should never hold that part by hand, for three good …
Source
If you bring your square blank closer to a cylinder before you start turning, it’s easier.
Read moreGambler’s Micro-Adjust Precise fence adjustments are a sure bet when I clamp this shop-made device on my router table. I simply drilled and tapped a hole to accept a 1/4″-20 machine screw through the center of a 3/4-in. by 1-in. …
Source