Edge-joining Thin Boards
Thin boards glued edge to edge have a tendency to spring out of place when pressure is applied to the bar clamps. A simple solution is to use short, notched clamping cauls at the ends of the joints. The cauls …
Source
Category Archives: Techniques
Easy-Read Speed Squares
I really like bright-colored speed squares because they’re easy to locate on the job, but I find them difficult to read. To solve this problem, I spray-painted my speed squares black. After they were dry, I used a 3M Scotch-Brite …
Source
Hard-Line Dust Piping: Best Practices
Follow these best practices to get the most out of your dust collection system. I don’t think that there has been something that’s increased my enjoyment in the shop as much as getting a good dust collection system in place. …
Source
Replacing an old Hope Chest Lock – Part 2
After fine-tuning the quirks with the new replacement lock and its brass catch plate, I turned my attention to the cedar hope chest’s half-mortise. I measured and compared the existing depth and width of the half-mortise with the dimensions …
Sou…
Bench Stop for Thin Stock
I use a hand plane to remove milling marks, even on pieces that are 1/8″ thick or less. To hold the work, I made a stop whose top is only 1/32″ thick. When I’m planing wood that’s more than 3/8″ …
Source