Like most woodworkers, I never have enough clamps. Adding to a clamp collection is expensive, so when I needed some deep reach clamps, I made these auxiliary hardwood jaws. The jaws are mortised to slide on the clamp’s bar. You …
Source
In need of some quick lumber storage, I rummaged around my shop for a solution. I discovered a length of PVC pipe left over from a plumbing job and cut it into three 12″ pieces. I also found some 1/2″ …
Source
Efficient storage is important in my garage shop, so after use, my assembly tables tip, fold, clamp and roll. Each table has one apron-mounted caster ($10 at a home center). I used two sheets of 3/4-in. plywood to make the …
Source
Cost, time, and a spouse’s patience help determine the course of action. Editor’s note: This article was originally published in the November 2009 issue of Popular Woodworking. It’s a dilemma nearly every woodworker must face. Whether you are a …
Read moreI made this rack so the finish on my small projects would dry without leaving marks. I cut strips off of a 3/4″ board with my tablesaw’s blade tilted 30 degrees. For each new strip, I just flipped the board …
Source