Tenon Preview
A tenon should be one-third the thickness of a rail—at least, that’s what an old rule of thumb recommends. A 3/4″ board should have 1/4″ tenons, for example. But what about a 7/8″ board? What’s one-third of that? I use …
Source…
Category Archives: Tricks of the Trade
Zero Clearance Dust Port
Zero clearance inserts are wonderful for eliminating tear out, but unfortunately, they also eliminate dust collection. To give my collection system an opening to pull sawdust through, I cut a 1/2-in.-dia. hole at the front end of the blade slot. ……
Read moreClamp Spacers
While I was gluing up the pedestals for an oak desk, I realized I needed a way to hold the sides parallel at the front. Three Quick-Grip clamps and a scrap wood spacer did the trick. They installed in seconds …
Source
In Praise of Parchment Paper
Need a non-stick glue-up surface for your next project? The perfect solution can be found in your kitchen.
The post In Praise of Parchment Paper appeared first on Woodworking | Blog | Videos | Plans | How To.
Read moreNo-Fuss Flush Trimming
My flush-trimming setup allows trimming veneer and solid wood edging up to 7/8-in. thick. It consists of a router with a 1/2-in. straight bit, a table and a perpendicular fence. A 1″-thick spacer separates the fence and table. The router …
…