Launder Your Sanding Belts
When I’m sanding pitchy wood or removing old finish, my sandpaper gets really gummed up and I can’t get it clean with the rubber eraser-type cleaner. I used to throw it away and buy more. Now, I pour some resin …
Source
Category Archives: Tricks of the Trade
Unjamming a Hole Saw
Hole saws provide an inexpensive way to bore large holes, but they have a maddening tendency to clutch the drilled disk afterward. I’ve found that the best approach for removing a stuck disk from the saw is to clamp it …
Source
Double Duty Peg-Blocks
I needed a way to lift pieces off the surface of my bench for finishing, so I made some 3/4″ x 2″ x 3″ blocks and inserted 1/4″ x 1-1/4″ dowels into them. Here’s the bonus: I discovered that if …
Source
Lumber-Drying Clamps
I’ve dried my own lumber for years, but I always had a problem getting enough weight on top of the stack, to keep the upper boards from warping. Here’s a solution: Use clamps made from threaded rods. Start building the …
Source
Routing Small Pieces
Whenever creating small pieces that include a routed detail of some sort, it’s best to do the routing on the larger “parent” board, and then separate the small piece from the larger. However, this isn’t always possible, and you may …
Source