Frankenstein’s Pencil
I like to use carpenter’s pencils until they’re worn down to stubs. Stubs aren’t very handy, though–they’re hard to dig out of a pocket. To solve this problem, I gathered up all the stubs lying around the shop and cut …
Source
Category Archives: Workshop Tips
Tablesaw Assembly Clamp
My tablesaw’s top often does double duty as an assembly table. It’s a guaranteed-flat surface. When I glue or screw together a project, it won’t come out twisted. Sometimes I use the saw’s fence as a clamp to hold parts …
Source
Kicker Chock Block
I love the convenience of mobile bases, but I hate it when they wobble on the floor even when they’re locked down. I got my chock block idea at the airport where the ground crews use something similar for parked …
Source
Router Table Extension Rail
I made some half-overlay frame-and-panel doors recently, installing the panel a bit proud of the rails and stiles on the front, which recessed the panel on the back side. This isn’t an aesthetic problem, but it does create difficulty when …
Source
Instant Rasp
I recently built a chest of drawers with sliding-dovetail joinery. During assembly, I found that the fit was just a little too snug. Rather than trying to realign my router jig, I looked around for another solution. I needed something …
Source