Hose System Simplifies Dust Collection
A shop made solution allows multipl tools to hook up to one shop vac.
Read moreCategory Archives: Workshop Tips
T-slot Bridge Clamp
I make my own zero-clearance throat plates for my table saw to minimize exit tear-out on workpieces and to prevent narrow pieces from dropping into the saw. When raising the blade through the insert blank for the first time (using …
Source
Pattern-Cut Finials
The traditional way to make a square finial on a bandsaw is to mark and cut the pattern on one side of the blank, then tape the offcut back on in order to guide the cuts on the adjacent side. …
Source
Easy Mitered Banding
I like to augment tabletops and drawer fronts with decorative banding, inlaying it around the perimeter. The problem has always been the fussy trimming of the mitered corners. It’s hard to cut the miters perfectly using a chisel freehand while …
…
Knee-Saving Compressor Drain
Crouching to operate my compressor’s drain valve was no big deal until my football-ravaged knees started acting up. To keep from grimacing in the sawdust, I devised a more civilized way to clear the tank. I replaced the drain value …
Source