Marking Gauge Refills
The blade of a marking gauge must be as sharp as a scalpel in order to cut a fine line across the grain. Sharpening it can be very difficult because it’s so small. I solved that problem by making a …
Source
Category Archives: Workshop Tips
Melamine tape makes drawers glide smoothly
Edge-banding tape on the bottom of drawer pockets creates a perfect gap.
Read moreAccurate Angled Holes
Accurately drilling an angled hole with a hand drill is a challenge – particularly if you’re using a brad point or Forstner bit. This angled drilling guide solves the problem handily. The guide keeps the drill bit from wandering as …
Source
Sawing with Sticky Notes
When using my miter saw, I’ve found that the easiest way to sneak up on a line is to use a stack of sticky notes. First, set a stop block to cut your part slightly oversize (1/16″ is plenty). …
Source
Rough out turnings at the router table
If you bring your square blank closer to a cylinder before you start turning, it’s easier.
Read more