Blowout Beater
A coping sled is a must-have accessory for router table work. It helps you hold a narrow piece, such as a door rail, perpendicular to the fence and backs up the cut to prevent blowout. At least, it’s supposed to. …
Source
Category Archives: Workshop Tips
Budget Spring Clamp
This light-duty clamp is ideal for small parts-and easy to make by the dozen. All you need are a couple wood scraps, a rubber band, and a short piece of dowel rod. You can vary the pressure by changing the …
Source
Tablesaw Trap
Even with a zero-clearance throat plate in my tablesaw, a thin cut-off slips through now and then. These pieces can clog a vacuum hose or damage the blades of a dust collector. I made a trap to catch them by …
Source
Workshop tip: Make a beam compass from common supplies
This drawing tool is easily made from two compasses and a yardstick.
Read moreRouter Bit Nest
Watching an expensive router bit roll onto the floor is a heartbreaking experience. In the middle of a project, it can be a disaster. I drilled a few 1/2” and 1/4” holes in the edge of a piece of MDF …
Source