Workshop Tip: Protect clamp bars with waxed paper
This precaution keeps glue squeeze-out from gumming up your clamps.
Read moreCategory Archives: Workshop Tips
Make Accurate Inside Measurements
Every woodworker knows not to rely on inside measurements made with a tape measure. Instead, I use two steel rules with dimensions that run to the edges. I butt one rule at each end, so the graduations overlap. To calculate …
Source
Cheesy Dado Shims
While looking around the shop to find a shim for my dado set, I saw the plastic lid from a cottage cheese container in the trash. Hmm, I thought, that could be it. I trimmed away the edge and measured …
Source
Shop-made Beam Compass
In my work I often need to draw large-radii curves, for which I use this long beam compass. Built from scrap wood and a dowel center, it’s cheap and easy to make in any length. It can be quickly adjusted …
Source
Workshop Tip: Simple, effective setup for trimming plywood edging
Simple setup works on router table or shaper.
Read more