Turning Tune-up
I can’t stand throwing away good wood. When I’m turning a goblet or any other object, I don’t leave the waste areas blank. I pick up a gouge or a skew and use the waste to perfect my turning techniques. …
Source
Category Archives: Workshop Tips
Safer Ripping of Short Stock
Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the spinning …
Source
Safer Ripping of Short Stock
Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the spinning …
Source
Workshop Tip: Protect clamp bars with waxed paper
This precaution keeps glue squeeze-out from gumming up your clamps.
Read moreMake Accurate Inside Measurements
Every woodworker knows not to rely on inside measurements made with a tape measure. Instead, I use two steel rules with dimensions that run to the edges. I butt one rule at each end, so the graduations overlap. To calculate …
Source