Drawer Stop Screws
Making an inset drawer line up flush with the face of a cabinet can be fussy work. To make it easy, I just install two screws on the back of the drawer and turn them until the drawer’s front is …
Source
Category Archives: Workshop Tips
Snipe-free Planing
Like most planers, mine snipes, overcutting a bit at both ends of a board. Sometimes I’ll simply cut off the sniped areas if I can afford the extra board length. However, with precious woods, that can mean trashing a few …
Source
Taming Handplane Tear-out
Nothing in handplaning is more frustrating than tear-out
Source
Popping Plugs
After cutting out plugs on the drill press, I used to saw them from their blank using the table saw. Unfortunately, this would often send the freed plugs flying across the shop, forcing me to hunt for them afterward. I …
Source
Workshop tip: Fine-tune your mortiser with a small stick
Clamping on a straightedge makes it easier to see if the small chisel is parallel with the machine’s fence.
Read more