Shop-made Beam Compass
In my work I often need to draw large-radii curves, for which I use this long beam compass. Built from scrap wood and a dowel center, it’s cheap and easy to make in any length. It can be quickly adjusted …
Source
Category Archives: Workshop Tips
Workshop Tip: Simple, effective setup for trimming plywood edging
Simple setup works on router table or shaper.
Read moreWorkshop Tip: Turn a drafting square into a shop square
All you need is some gray primer and a plastic drafting square.
Read moreReversible Bench Hook
Like many woodworkers, I use a bench hook to support small pieces on the bench for handsawing. A typical bench hook is just a small panel with a shortened topside fence at one end for supporting the workpiece and a …
Source
Offset Detail Sander
When doing repair work, I often have to inlay small patches of wood into a finished surface. To help level the patch afterward without marring the adjacent surface, I made up several of these little detail sanders, band sawing them …
Source