Safer Ripping of Short Stock
Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the spinning …
Source
Category Archives: Tricks of the Trade
Make Accurate Inside Measurements
Every woodworker knows not to rely on inside measurements made with a tape measure. Instead, I use two steel rules with dimensions that run to the edges. I butt one rule at each end, so the graduations overlap. To calculate …
Source
Cheesy Dado Shims
While looking around the shop to find a shim for my dado set, I saw the plastic lid from a cottage cheese container in the trash. Hmm, I thought, that could be it. I trimmed away the edge and measured …
Source
Shop-made Beam Compass
In my work I often need to draw large-radii curves, for which I use this long beam compass. Built from scrap wood and a dowel center, it’s cheap and easy to make in any length. It can be quickly adjusted …
Source
Drilling for Continuous Hinges
Self-centering drill bits (also called “Vix bits”) are great for quick, accurate drilling of hinge screw holes. Unfortunately, they don’t work very well for many continuous, or “piano,” hinges. That’s because the leaves on continuous hinges often are t…
Read more